If this is your first visit, be sure to check out the FAQ by clicking the link above.
You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
Er det noen fordel med en balsa ramme rundt i utsparingen til
servoen som felles inn i vingen,vil styrken bli bedre eller har den ingen funksjon
annet enn at det ser finere ut?
Nan Xplorer FullCarbon X tail
Pike Perfect X tail
Pike Brio / Giant
Alpina 4001
DG 500/22 Elan under opppussing
Birde of Time ( Noe redusert må restureres )
Beste måten og feste servo i isoporvinger er og lage hullet med loddebolt, for da blir det ingen smuler og isopor rundt hullet blir hard. der etter tar du litt smeltelim( slike billige smeltepistoler til 39 kr på biltema eller Clas Ohlson er helt super) og tar rundt servoen. sitter som et skudd og lett og få løs om du trenger det.
mvh Kjetil Sandal www.modellfly.no
-----------------------------------------------------------------------
Hvis flyet ikke vil taxe selv med full motor kan det være det ligger på rygg..
We process personal data about users of our site, through the use of cookies and other technologies, to deliver our services, personalize advertising, and to analyze site activity. We may share certain information about our users with our advertising and analytics partners. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Comment