If this is your first visit, be sure to check out the FAQ by clicking the link above.
You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
Dersom det er glassfiber bør det ikke være noe problem, men ABS vil heller ikke smelte med mindre den ligger intil manifolden (Har prøvd ). Men det er noen andre faktorer å tenke på:
- Kjøling. Ser ikke ut som et problem her, men husk at motoren må ha plenty luft rundt sylinderen!
- Alle utkapp bør/må ha avrundete kanter! Dersom du har en Dremel er det bare å pusse til, hvis ikke tar du kanske enkelt litt 120 sandpapir, ruller det, og pusser i veg!
Alle skarpe kanter vil få en spenningskonsentrasjon som gjør at det danner seg sprekker der, og DET vil vi ikke ha, vil vi vel??
We process personal data about users of our site, through the use of cookies and other technologies, to deliver our services, personalize advertising, and to analyze site activity. We may share certain information about our users with our advertising and analytics partners. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Comment