If this is your first visit, be sure to check out the FAQ by clicking the link above.
You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
The 19mm-diameter, 13mm-long stator means that the motor can handle up to 160 watts continuous input power, depending on the wiring and battery you choose. The motor diameter less than 24mm so, when assembled with the 2mm shaft ...
Originally posted by www.aircraft-world.com
Dimensions:
Motor Outside Diameter: 23.45mm
Length excluding shaft: 25.3mm
Output Shaft Length: ~10mm
Weight fully assembled: 39.8g
Here are the parts included:
Custom Steel/Aluminum Bell assembly with "fingers" for perfect positioning of the 8 magnet poles
6-pole stator measuring 19mm OD by 13mm long
8 pcs 13x6x1mm Neodymium N48 120C Magnets
0.30 mm wire (enough for two winding sessions)
Shrink tube for the motor wires
3mm hard, polished shaft with two clip positions for front or back mounting
3mm shaft with 2mm output section to fit "Speed 300" gearboxes and EDF
We process personal data about users of our site, through the use of cookies and other technologies, to deliver our services, personalize advertising, and to analyze site activity. We may share certain information about our users with our advertising and analytics partners. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Comment