Rekonstruksjon av ribber

[OJ]

Poster denne under scratchbygging hehe.....

Noen som har gode råd av hvordan man kan rekonstruere de ytterste ribbene på Extraen min etter et ubidt møte med landingslysene på Rena under NM i Imac?

Uten å måtte brekke opp på den andre vingen?

mvh
Odd Johnny

[Celtic-Griffin]

Reproduce the section at the wing root by careful measurement of the profile coordinates and scale it to the various chords you need...or do the same on the ribs you need from the opposite wing. This is easily done by supporting the wing on the bench with the root chord parallel to the bench and with a parallel bridge over the wing with the chord stations marked measure from the bridge down to the undamaged wing surface. This wing is a ruled surface so the root tip stringers are all straight lines - simple geometry will give you what you need.