group order: 40mm, 18slot statorlaminations

[ron van sommeren]

Ralph Okon (a.k.a. http://www.powerditto.de ) is putting together a group order for 40mm. diameter, 18pole statorlaminations. A minimum order of 5000 laminations is needed to start a production run. Minimum order per person is 50. One 0.20mm lamination (NO20 iron quality) will cost 0.5€. Flux ring and frontplates will probably also be available by then. Keep in mind, this is not a business for Ralph, he's in the business of curing people

More info on ordering;

http://www.rcgroups.com/forums/showthread.php?t=392627

I'm posting this in several lists/forums, think it's best if we all discussed/asked in the thread above.

[ron van sommeren]

I think, you should better calculate with ca. 4 per mm, because of the needed insulation between the plates. in summery 40 up to 45 per cm I think.

we are looking now for curved magnets for the project.
it seems, if there are enough users who join the project,
ist could give a complete set (can, bearings, etc.) for the motor.
lenght then 5, 10 and 15mm in first attempt.

and the baby has a name now:
its our "CROCODILE"

-has many teeth too, more then the others
-seems to be leazy, but is a very powerfull animal.
- there are big elektrical lokomotives(?) for railway, also named so:

http://www.ozdoba.net/rhb/croco_d.html

if you are interested in more details, please have a look at

https://www.powerditto.de/crocodile-project.html

we have orders for 2000 statorplates now and we need minimum 5000 to get this very good price.....

viele grüsse,
ralph

www.powerditto.de

[ron van sommeren]

Turned parts, magnets, shafts, ball bearings will be available too. See:

English

http://www.rcgroups.com/forums/showthread.php?t=392627

http://www.powerditto.de/crocodile-projectengl.html

Deutsch

http://www.rclineforum.de/forum/thread.php?threadid=88112&sid=&threadview=0&hilight=&hilightuser=&page=4

http://www.powerditto.de/crocodile-project.html

Remember, this is not a commercial thing, it's a group design project from the diy motor builders at

http://www.rclineforum.de/forum/board.php?boardid=29

[ron van sommeren]

Pre-ordering shafts, fluxring, mounting plate, drive plate, statorcarrier etc (English & German):

http://www.croco-power.de/