If this is your first visit, be sure to check out the FAQ by clicking the link above.
You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
hoved rotor aksling har vertikal vandring på 4-5mm :/
har ikke montert servoene enda da, men som det står nå tar drivtannhjulet på aksling, som ligger imot tannhjul på motor, imot rammen :/ går altså ann og løfte opp hoved aksling med alt, 4-5mm... er dette rett :?
Er en CopterX 500se det er snakk om(stortsett samme som t-rex 500).
Er det så at servoene ska holde aksling i rett høyde eller ?
We process personal data about users of our site, through the use of cookies and other technologies, to deliver our services, personalize advertising, and to analyze site activity. We may share certain information about our users with our advertising and analytics partners. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Comment